Item #W002-109
1-1/2" Stainless Horizontal outlet exhaust thru hull. Includes heat resistant gaskets. Belled on one end. For Webasto or other heaters using 1-1/2" rigid exhaust.
|
Item #001-449
1/4" USCG Approved Type A1 Fuel Hose.
|
Gar-Ber #W11BVRK
Fuel Filter KitIncludes filter housing, filter, mount bracket, valve, vacuum gauge and fittings to adapt to 1/4" hose. Other adapters available upon request.
|
Retail Price: $51.09
Our Price: $45.98
You Save: $5.11 (10 %)
Aube #TH135-01
Digital Thermostat with Day, Night and Vacation Modes Temperatures can be set individually for day, night, and vacation settings.
|
Item #W005-378K
System Heat Switch For heater system control. It can be used on all heating systems.
|
Item #W002-911.36
Hi/Low Switch with Off For one or more 12 volt fans with a total amp draw of up to 0.52 amps.
|
Item #W002-911.70
Hi/Low Switch with Off For one or more 12 volt fans with a total amp draw of up to 0.99 amps.
|
Item #75135K-30
20 Amp Inline Manual Reset Breaker Kit A main system breaker to protect the entire heating system. Includes rubber wire boots. Per ABYC standards this should be installed within 72" of the battery connection.
|
Item #W002-103
This 9" diameter tank is made of steel and comes with 3/4" FNPT fittings, mount brackets, and 7# pressure cap. It can be used in Webasto or other marine hydronic heating systems with over 10 gallons capacity like the DBW2010.
|
Item #W002-105B
This 12" diameter tank is made of steel and comes with 3/4" FNPT fittings, mount brackets, and air bleeder. The greater volume of water your marine hydronic heating system has the less likely it will short cycle.
|
MP Pumps #MP1200-12 12 Volt 15 Gallon Per Minute Shaft Drive Circulation Pump for 3/4" Heater Hose
Pumps 15 Gallons Per Minute of heated coolant from your Webasto or other diesel hydronic heater. For systems with up to 125 total feet of hose.
|
3/4" (19.1) "Boston Bosflex" Commercial Grade Heater Hose
Reinforced specifically for use in heating systems. Rated 225 P.S.I.
Sold by the foot.
|
Retail Price: $25.67
Our Price: $21.82
You Save: $3.85 (15 %)
STA-CLEAN Antifreeze - Propylene Glycol Low Silicate SCA-Precharged
Gallon
|
Coolant Treatment Kit for DBW 2010 or DBW 2015
Designed to Keep Hydronic Systems Coolant pH from Becoming Corrosive
|
3/4" Hose Inline Boiler Drain Ball Valve with 3/4" Male Garden Hose Drain Port
Inline Brass Boiler Drain Ball Valve with 3/4" Male Garden Hose Drain Port
|
Item #W005-212-KIT
3/4" Hose Inline Aquastat For control of system fan heaters. It will keep all fans in the system off until the system reaches 110 degrees F.
|
Item #W005-110
1-1/2" Stainless long exhaust elbow with condensation drain for rigid exhaust. Belled on one end. For Webasto or other marine heaters using 1-1/2" rigid exhaust.
|
3/4" Brass Hose Barb x 3/4" Brass Hose Barb Ball Valve
Hose Barb to Hose Barb Brass Ball Shutoff Valve
|
CLA-012 S/S Double Band Hose Clamp Min. 1/2" - Max. 1-1/4" Opening
300 Series Stainless Steel Band and Housing with Extended Band to Protect Clamped Surface with a 300 series Stainless Steel Deep Slotted 5/16" Hex Head Screw
|
Retail Price: $216.14
Our Price: $194.53
You Save: $21.61 (10 %)
The REAL Heat 6013 3,500 Btu Marine Hydronic Fan Heater has a 3-inch outlet designed to duct airflow to an adjacent space or to accommodate tight installations. This kit includes three feet of 3-inch duct and a 3-inch grille.
|
Retail Price: $334.31
Our Price: $300.88
You Save: $33.43 (10 %)
The REAL Heat 6414 14,000 Btu Marine Hydronic Fan Heater has a 4-inch outlet designed to duct airflow to adjacent spaces or to accommodate tight installations. This kit comes with four feet of 4-inch duct and one 4-inch grille.
|
Item #W001-214
1-1/2" Stainless steel rigid exhaust. Sold by the foot up to 20 feet. For Webasto or other marine heaters using 1-1/2" exhaust.
|
Item #W002-780
1-1/2" stainless steel exhaust clamp. For Webasto or other marine heaters using 1-1/2" exhaust.
|
Item #W001-441
1-1/2" Marine lace-on high temperature exhaust insulation (shown installed on exhaust tube). Available in finished lengths of 1 ft, 2 ft, 3 ft, 4 ft, and 5 ft. Specify lengths and quantities when ordering.
|
Retail Price: $289.41
Our Price: $260.47
You Save: $28.94 (10 %)
The REAL Heat 6214 7,000 Btu Marine Hydronic Fan Heater is a 4-inch outlet heater designed to provide a greater airflow to adjacent spaces and to ease space concerns. This kit includes four feet of 4-inch duct and one 4-inch grille.
|
Retail Price: $366.47
Our Price: $329.82
You Save: $36.65 (10 %)
The REAL Heat 6424 14,000 Btu Marine Hydronic Fan Heater provides two 4 inch outlets designed to split the airflow to separate spaces or to accommodate tight installations. This kit comes with six feet of 4-inch duct and two 4-inch grilles.
|
Item #77649
Furnace cement. Sealant for joints in the exhaust system. Capable for use on all systems.
|
Retail Price: $8.64
Our Price: $6.05
You Save: $2.59 (30 %)
Item #PERM-81878
Permatex Ultra Copper. High temperature RTV Sealant for joints in the flexible exhaust systems and for the bedding of exhaust thru hulls.
|
W005-220 Mounting Shelf Bracket for DBW 2010 / DBW 2015 Powder Coated Aluminum
|
W600-014K DBW 2010 / DBW 2015 Rubber Shock Mount Kit
|