Retail Price: $396.42
Our Price: $356.78
You Save: $39.64 (10 %)
The REAL Heat 5433 25,000 Btu Marine Hydronic Defroster / Heater is a triple 3-inch outlet heater for use as a defroster, to heat a single space or several smaller spaces. This kit includes 10 feet of 3-inch duct and three 3-inch grilles.
|
Retail Price: $210.52
Our Price: $189.47
You Save: $21.05 (10 %)
The REAL Heat 6013 3,500 Btu Marine Hydronic Fan Heater has a 3-inch outlet designed to duct airflow to an adjacent space or to accommodate tight installations. This kit includes three feet of 3-inch duct and a 3-inch grille.
|
Retail Price: $280.11
Our Price: $252.10
You Save: $28.01 (10 %)
The REAL Heat 6214 7,000 Btu Marine Hydronic Fan Heater is a 4-inch outlet heater designed to provide a greater airflow to adjacent spaces and to ease space concerns. This kit includes four feet of 4-inch duct and one 4-inch grille.
|
Retail Price: $301.33
Our Price: $271.20
You Save: $30.13 (10 %)
The REAL Heat 6414 14,000 Btu Marine Hydronic Fan Heater has a 4-inch outlet designed to duct airflow to adjacent spaces or to accommodate tight installations. This kit comes with four feet of 4-inch duct and one 4-inch grille.
|
Retail Price: $330.15
Our Price: $297.14
You Save: $33.01 (10 %)
The REAL Heat 6424 14,000 Btu Marine Hydronic Fan Heater provides two 4 inch outlets designed to split the airflow to separate spaces or to accommodate tight installations. This kit comes with six feet of 4-inch duct and two 4-inch grilles.
|
Item #77649
Furnace cement. Sealant for joints in the exhaust system. Capable for use on all systems.
|
Retail Price: $8.22
Our Price: $6.17
You Save: $2.05 (25 %)
Item #PERM-81878
Permatex Ultra Copper. High temperature RTV Sealant for joints in the flexible exhaust systems and for the bedding of exhaust thru hulls.
|
Item #W002-124
2-3/4" Stainless Horizontal outlet exhaust thru hull. Includes heat resistant gaskets. Belled on one end. For Webasto or other marine heaters using 2-3/4" exhaust.
|
Item #W002-743
2-3/4" Stainless steel rigid exhaust. Sold by the foot up to 20 feet. For Webasto or other marine heaters using 2-3/4" exhaust.
|
Item #W001-886
2-3/4" lace-on high temperature exhaust insulation (shown installed on exhaust tube). Available in finished lengths of 1 ft, 2 ft, 3 ft, 4 ft, and 5 ft. Specify lengths and quantities when ordering. With siezing wire.
|
Item #001-449
1/4" USCG Approved Type A1 Fuel Hose.
|
Gar-Ber #W11BVRK
Fuel Filter KitIncludes filter housing, filter, mount bracket, valve, vacuum gauge and fittings to adapt to 1/4" hose. Other adapters available upon request.
|
Aube #TH135-01
Digital Thermostat with Day, Night and Vacation Modes Temperatures can be set individually for day, night, and vacation settings.
|
Item #W005-378K
System Heat Switch For heater system control. It can be used on all heating systems.
|
Item #W005-212MPT
3/4" Male NPT Inline Aquastat For control of system fan heaters. It will keep all fans in the system off until the system reaches 110 degrees F.
|
Item #75135K-30
20 Amp Inline Manual Reset Breaker Kit A main system breaker to protect the entire heating system. Includes rubber wire boots. Per ABYC standards this should be installed within 72" of the battery connection.
|
Item #W002-105
This 12" diameter tank is made of steel and comes with 3/4" FNPT fittings, mount brackets, and 7# pressure cap. It can be used in Webasto or other marine hydronic heating systems with over 10 gallons capacity like the DBW2020.
|
Item #W002-105B
This 12" diameter tank is made of steel and comes with 3/4" FNPT fittings, mount brackets, and air bleeder. The greater volume of water your marine hydronic heating system has the less likely it will short cycle.
|
Grundfos #UP2664FKIT 110 Volt AC 26 Gallon Per Minute Mag Drive Circulation Pump for 1-1/2" Heater Hose
With built-in three speed switch. Pumps 26 Gallons Per Minute of heated coolant from your Webasto or other diesel hydronic heater.
|
W003-100 12 Volt DC - 110 Volt AC Pump Interlock Box.
Allows an 110 Volt AC pump to be controlled by a 12 Volt DC source (like the control unit on a Webasto heater, for instance).
|
3/4" (19.1) "Boston Bosflex" Commercial Grade Heater Hose
Reinforced specifically for use in heating systems. Rated 225 P.S.I.
Sold by the foot.
|
1-1/2" (38mm) "Trident-Flex" Wire Wound Water Hose
Rated 250 F. Degree (120 C. degree)
Sold by the foot.
|
W600-015K DBW 2020 Rubber Shock Mount Kit
|
W005-131 Mounting Shelf Bracket for DBW 2020 Powder Coated Aluminum
|
CLA-012 S/S Double Band Hose Clamp Min. 1/2" - Max. 1-1/4" Opening
300 Series Stainless Steel Band and Housing with Extended Band to Protect Clamped Surface with a 300 series Stainless Steel Deep Slotted 5/16" Hex Head Screw
|
CLA-024 S/S Double Band Hose Clamp Min. 1/2" - Max. 1-15/16" Opening
300 Series Stainless Steel Band and Housing with Extended Band to Protect Clamped Surface with a 300 series Stainless Steel Deep Slotted 5/16" Hex Head Screw
|
STA-CLEAN Antifreeze - Propylene Glycol Low Silicate SCA-Precharged
Gallon
|
Coolant Treatment Kit for DBW 2020
Designed to Keep Hydronic Systems Coolant pH from Becoming Corrosive
|
3/4" Hose Inline Boiler Drain Ball Valve with 3/4" Male Garden Hose Drain Port
Inline Brass Boiler Drain Ball Valve with 3/4" Male Garden Hose Drain Port
|
Item #W002-663
2-3/4" stainless steel exhaust clamp. For Webasto or other marine heaters using 2-3/4" exhaust.
|