Easy Start your A/C without buying a second or bigger generator or inverter
Run 2 air conditioners on a 30-Amp cord. (Note: Each A/C requires an EasyStart unit - Results depend on the power management system and the total amperage MUST be less than 30 AMPS and does NOT reduce running AMPS.
Sleep, with less noise, and cool all through the night
Run your A/C with more appliances at the same time
Add an A/C unit at low cost by putting an inexpensive EasyStart on each. Avoids expensive rewiring of the entire RV to upgrade to 50-amp.
Convenient installation kit for wiring an RV Rooftop A/C unit is available. (sold separately)
Has numerous specialized fault checks not found in any other soft starter to provide further protection for your compressor.
The EasyStart includes a unique water resistant and UV protected enclosure with an integrated mounting flange.
Specialized models exist for various applications.
This EasyStart model comes equipped with side-angled “flag connectors to attach to the run capacitor in your installation. They work well in any limited space. If you prefer, you may clip them off in favor of your preferred connector.
Improve Your Starts with EasyStart™
EasyStart™ - The most advanced & effective soft starter for all A/C applications EasyStart™ is a one-of-a-kind, custom-developed soft starter for single-phase motors. It employs a 4-part start ramp sequence that is self-optimizing, resulting in the lowest possible start-up current. EasyStart can deliver 65-75% start current reduction as compared to a compressor's LRA (locked-rotor amperage). EasyStart is the perfect solution that allows an air conditioner or refrigeration compressor to operate on a generator, inverter, or limited utility power when it would otherwise not have functioned. It can also be applied to air compressor and fluid pump motors
EasyStart™ is the perfect solution that allows an air conditioner to operate on a generator, inverter or limited utility power when it would otherwise not have functioned.
Wire Harness Length:
40 in (1m)
IMPORTANT INSTALLATION NOTE FOR CRUISAIR® MARINE CUSTOMERS ONLY:
When installing EasyStart into 220-240V SMX A-288/282/281 control applications that use the triac to switch power to the compressor, it is necessary to replace the triac with a relay. If the triac is not replaced, the EasyStart and any pump relay triggers may suffer damage and ultimately fail. A replacement relay specifically designed for this application is available at this link. Please note that this is not required for 115V SMX applications, and the triac is still safe to use.
These warnings are not an indication that these products are violating any safety standards or regulations.
However, as our products might be sold in the state of California, we are legally obliged to inform customers about the potential presence of these chemicals in our products.
